Downloads: 127 | Views: 216
Research Paper | Mechanical Engineering | India | Volume 7 Issue 4, April 2018 | Popularity: 6.6 / 10
Comparative Study and Optimization of Dry Sand Abrasive Wear Behavior of As-Cast and Retrogression and Re-Aging of 7075 Aluminum Alloy using Taguchi and ANOVA
Jagannath, Hemavathy S
Abstract: For the past many years 7075 aluminum alloy widely used in aircraft structural parts where high wear resistance are required wear rate are reduced by the retrogression and re- aging heat treatment (RRA). Three body sand abrasive wear test is conducted on both as-cast and retrogression and re-aging specimens as per Taguchis experimental design and L9 orthogonal array wear parameters like time, load, and speed are considered and track diameter kept constant it is found that when wear resistance of retrogression and re-aging heat treated (RRA) specimen is more as compared to the as-cast specimens. The design of experiments (DOE) approach using taguchi method was employed to analyze the abrasive wear behavior of material. Signal-to-noise ratio and analysis of variance (ANOVA) were used to investigate the influence of parameters on the wear rate and also determine the optimal parameters for minimizing the wear rate.
Keywords: AL-7075 alloy, retrogression and re-aging, sand abrasive wear, Taguchis orthogonal array, ANOVA
Edition: Volume 7 Issue 4, April 2018
Pages: 1688 - 1692
Similar Articles
Downloads: 105
Research Paper, Mechanical Engineering, India, Volume 3 Issue 11, November 2014
Pages: 2865 - 2869Dry Sliding Wear Behaviour of Al-Si-Ti Alloys Using Taguchi Method
Ganpat B. Jambukar, Dr. Y. R. Kharde
Downloads: 117
Research Paper, Mechanical Engineering, India, Volume 4 Issue 1, January 2015
Pages: 2699 - 2702Optimization of End Milling Parameters on Surface Roughness of Die Steel HCHCr by Taguchi Method
M. S. Harne, Ravikumar L. Shirsat
Downloads: 119 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1
Research Paper, Mechanical Engineering, India, Volume 5 Issue 3, March 2016
Pages: 1988 - 1994Optimization of Process Parameters of Friction Stirs Welding of Aluminum Alloys (6061) Using Taguchi Method
Siva Rama Krishna R, Pavan Kumar T
Downloads: 120
M.Tech / M.E / PhD Thesis, Mechanical Engineering, India, Volume 8 Issue 12, December 2019
Pages: 1622 - 1629Some Investigations on Drilling of Aluminium Based Metal Matrix Composites
Vinodkumar M. Chandankar, Aarti A. Dyade
Downloads: 121
Research Paper, Mechanical Engineering, India, Volume 4 Issue 6, June 2015
Pages: 102 - 108Experimental Damping Estimation of Material by Sinusoidal Base Excitation
Amit Kumar Gupta, S K Mangal