Downloads: 150 | Views: 343
Research Paper | Mechanical Engineering | India | Volume 5 Issue 10, October 2016 | Popularity: 7 / 10
Performance Evaluation of MQL on AISI 4130 Steel on Universal Milling Machine
Rupesh M Parthe, Taqui Z Quazi
Abstract: Reducing the machining cost is the main aim of every production system. Cost of cooling and lubrication is major contributing factor in the cost of production. Flood type machining possess flow rate up to 20 L/Hr. , which uses more amount of cutting fluid. Completely dry machining is not possible because of heat generated in machining. Hence small but appropriate amount of lubrication must be applied. This method is called as near dry machining or Minimum Quantity Lubrication. Work is carried out on universal milling machine using material AISI 4130 alloy steel. Three levels of cutting speed and depth of cut were chosen and respective cutting temperature and surface roughness were recorded for both flood type and MQL technique. Flow rate in MQL is maintained 1.34 L/Hr. Output obtained by experimentation is analyzed on Minitab Software. Using ANOVA, regression analysis, main effect plot and interaction plot conclusion is drawn. There is 93.3 % reduction in use of cutting fluid. MQL gives 8.48 % reduction in tool temperature, this will improve tool life. MQL produced 19.13 % improved surface finish. For this work, cutting fluid applicator (spray gun) is manufactured. Findings of the study shows that, MQL appears to be economical and environmentally compatible lubrication technique for sustainable development.
Keywords: MQL, ANOVA, Regression analysis, Sustainable development
Edition: Volume 5 Issue 10, October 2016
Pages: 419 - 422
Make Sure to Disable the Pop-Up Blocker of Web Browser
Similar Articles
Downloads: 105
Research Paper, Mechanical Engineering, India, Volume 3 Issue 11, November 2014
Pages: 2865 - 2869Dry Sliding Wear Behaviour of Al-Si-Ti Alloys Using Taguchi Method
Ganpat B. Jambukar, Dr. Y. R. Kharde
Downloads: 117
Research Paper, Mechanical Engineering, India, Volume 4 Issue 1, January 2015
Pages: 2699 - 2702Optimization of End Milling Parameters on Surface Roughness of Die Steel HCHCr by Taguchi Method
M. S. Harne, Ravikumar L. Shirsat
Downloads: 119 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1
Research Paper, Mechanical Engineering, India, Volume 5 Issue 3, March 2016
Pages: 1988 - 1994Optimization of Process Parameters of Friction Stirs Welding of Aluminum Alloys (6061) Using Taguchi Method
Siva Rama Krishna R, Pavan Kumar T
Downloads: 120
M.Tech / M.E / PhD Thesis, Mechanical Engineering, India, Volume 8 Issue 12, December 2019
Pages: 1622 - 1629Some Investigations on Drilling of Aluminium Based Metal Matrix Composites
Vinodkumar M. Chandankar, Aarti A. Dyade
Downloads: 121
Research Paper, Mechanical Engineering, India, Volume 4 Issue 6, June 2015
Pages: 102 - 108Experimental Damping Estimation of Material by Sinusoidal Base Excitation
Amit Kumar Gupta, S K Mangal