International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 120

Research Paper | Manufacturing Engineering | India | Volume 8 Issue 1, January 2019


Performance of Cold Coolant for Machining of Inconel 718 using Carbide Cutting Tool

Selvarani P | Senthilkumaar J.S


Abstract: Inconel 718 machining is challenging and difficult task in the aspect of good surface quality and minimum tool cost by machining process with low tool wear rate. In this contest, cold coolant machining tries to find the solutions by reducing the tool wear significantly in turning processes. The usage of the cutting fluids and its machining conditions are critically significant in order to completely utilized in the machining process. Usually, the maximum heat generation at chip-tool interface as critical cutting zone, and friction between the tool face and work surface is always the crucial factor on the surface quality. A good understanding of the methods to apply the cold cutting fluid at the cutting zone may significantly reduce the heat generation in machining and thus reduce the tool wear then the surface roughness also improved. Surface roughness and tool wear are always used as a quality indicator of machined job. In this research frizzed ice placed near to the coolant pump to convert the coolant in cold condition. During turning of Inconel 718 flooded cold coolant were drastically removed heat from the chip tool interface. As result, the cold coolant allows a tool life better than the conventional cutting fluid, moreover longevity of the cooling fluid also maintained.


Keywords: Cold Coolant, Design of experiments, Inconel 718 machining, Flank wear, Surface roughness, Taguchi Optimization


Edition: Volume 8 Issue 1, January 2019,


Pages: 2191 - 2198


How to Download this Article?

You Need to Register Your Email Address Before You Can Download the Article PDF


How to Cite this Article?

Selvarani P, Senthilkumaar J.S, "Performance of Cold Coolant for Machining of Inconel 718 using Carbide Cutting Tool", International Journal of Science and Research (IJSR), Volume 8 Issue 1, January 2019, pp. 2191-2198, https://www.ijsr.net/get_abstract.php?paper_id=ART20194885

Similar Articles with Keyword 'Surface roughness'

Downloads: 0

Experimental Result Paper, Manufacturing Engineering, Vietnam, Volume 11 Issue 6, June 2022

Pages: 1224 - 1227

Multi-Objective Optimization of Turning Parameters to Minimize Surface Roughness and Material Removal Rate Using TOPSIS Combining Entropy Weight

Nguyen Anh Thang | Truong Van Luong | Tran Van Hieu

Share this Article

Downloads: 3 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Experimental Result Paper, Manufacturing Engineering, Turkiye, Volume 13 Issue 6, June 2024

Pages: 1748 - 1750

Investigation of the Effects of Cutting Parameters on Surface Roughness in Turning Operations

Bugra ARSLAN [2] | Ali Serhat ERSOYOGLU [4]

Share this Article
Top