International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 175 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Research Paper | Chemical Engineering | India | Volume 7 Issue 8, August 2018


Production of Acrylic Acid

Akanksha Puwar [2] | Kashish Jalan [2]


Abstract: This report provides a complete analysis of an alternate method of production of acrylic acid and highlights the advantages it has over the conventional methods. It covers all the aspects that one needs to consider while setting up a new production plant and thus can act as a suitable guide. Having established the need and profitability prospects of the setup of acrylic acid using ethylene over other possible mechanisms of production in the initial sections, the original hypothesis was proved correct. Following this, the various process flow chart and the process parameters were stated which emphasized the various equipment and raw materials required for the project and gave a rough estimate of the production capacity of the plant. An in-depth analysis was done by using Mass and Energy Balances which can be used to understand the material and power requirements for the process in terms of flow rates and utilities. The ideal break-up of this power requirement through heat exchangers and hot and cold utilities was done and an overall Heat Exchanger Network was drawn. ASPEN Simulations were run which computed and verified the more intrinsic values like all flow rates, composition, entropy and enthalpy values for the different process streams. The Process Flow Diagram gives a crisp representation of the overall design of the plant. Our HEN has 3 heat exchangers, 4 cold utilities and 1 hot utility. Note that this is the MER design which uses minimum utilities and maximum heat recovery. The economic analysis shows that the project has very heavy initial investment of over Rs.22 crores and thus makes it feasible for only those who have access to such heavy investment at a reasonable interest rate. However, the high rate of return (7.8 %) and low payback period (6.3 years) makes our investment worthwhile. Also, the annual profits are very high as compared to the operating cost which implies that in the long run, when the high initial investment is already recovered, our project will be highly profitable.


Keywords: Acrylic Acid Production, PTA analysis, Pinch analysis


Edition: Volume 7 Issue 8, August 2018,


Pages: 403 - 417


How to Download this Article?

You Need to Register Your Email Address Before You Can Download the Article PDF


How to Cite this Article?

Akanksha Puwar, Kashish Jalan, "Production of Acrylic Acid", International Journal of Science and Research (IJSR), Volume 7 Issue 8, August 2018, pp. 403-417, https://www.ijsr.net/get_abstract.php?paper_id=ART2019294

Similar Articles with Keyword 'Acid'

Downloads: 1 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Research Paper, Chemical Engineering, Brazil, Volume 11 Issue 6, June 2022

Pages: 516 - 531

Hydrogenation of Palm Esters to Fatty Alcohols using Re/Nb/Al2O3 Catalysts

Germildo J. Muchave | Joao M. A. R. Almeida | Donato A. G. Aranda

Share this Article

Downloads: 1 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Analysis Study Research Paper, Chemical Engineering, Jordan, Volume 11 Issue 12, December 2022

Pages: 570 - 574

Removing CO2 from Industrial Gas Streams by Adsorption into Jordanian Zeolite

Asem Mohammad AL Jarrah [2] | Reyad Ali AL Dwairi

Share this Article
Top