International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064

Downloads: 148 | Views: 262

Research Paper | Mechanical Engineering | Turkey | Volume 8 Issue 3, March 2019 | Rating: 6.2 / 10


The Effect of Different Chip Breaker Forms on Cutting Force and Surface Roughness in the Machining of AISI 304 Stainless Steel

Bugra ARSLAN [2] | Ali Serhat ERSOYOGLU [4]


Abstract: In this study, the effect of different chip breaker forms on cutting forces and surface roughness during chip removal process has been investigated experimentally. AISI 304 grade austenitic stainless-steel material was machined by the cutting tools with an ISO notation of WNMG O80408 EA, WNMG 080408 EM, WNMG 080408 MP and the effects of these factors on cutting forces and surface roughness values were determined. In the experimental studies, the highest cutting forces were obtained by the cutting tools with the EM coded chipbreaker form and the best surface quality was obtained by the MP coded cutting tool.


Keywords: AISI 304, Cutting forces, Surface roughness, Chip breaker form


Edition: Volume 8 Issue 3, March 2019,


Pages: 1320 - 1324



Rate this Article


Select Rating (Lowest: 1, Highest: 10)

5

Your Comments

Characters: 0

Your Full Name:


Your Valid Email Address:


Verification Code will appear in 2 Seconds ... Wait

Top