Rate the Article: Design and Analysis of Ring Shaped UWB Microstrip Patch Antenna with Coplanar Waveguide Fed, IJSR, Call for Papers, Online Journal
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064

Downloads: 138 | Views: 376

Research Paper | Electronics & Communication Engineering | India | Volume 7 Issue 5, May 2018 | Rating: 6.4 / 10


Design and Analysis of Ring Shaped UWB Microstrip Patch Antenna with Coplanar Waveguide Fed

Radwan Abdulhadi Elbasir, Anil Kumar


Abstract: A compact ultawideband antenna (UWB) is presented here with ring shaped structure consisting of triangular shaped patch in centre of ring. The antenna is fabricated onto Rogers R03003 substrate with an overall dimension of 47X47 mm. The substrate has dielectric constant of 3 and thickness of 1.6mm. The antenna is fed by a coplanar waveguide in order to have low radiation loss and impedance match. The simulated experiment shows that the proposed antenna achieves good impedance matching over an operating bandwidth of 2.22.7 GHz (20 %) and 3.2-15 GHz (129.67 %) that covers the entire UWB band. Its gain varies between 1.5 to 3 dBi for most of the frequency band. This makes the proposed antenna suitable for being used in UWB communication applications


Keywords: Ultra-wide band antenna, Waveguide fed, Microstrip patch antenna, Microwave


Edition: Volume 7 Issue 5, May 2018,


Pages: 382 - 384



Rate this Article


Select Rating (Lowest: 1, Highest: 10)

5

Your Comments (Only high quality comments will be accepted.)

Characters: 0

Your Full Name:


Your Valid Email Address:


Verification Code will appear in 2 Seconds ... Wait

Top