Rate the Article: Affect of the Different Irradiation Time and Light Density on the Shear Bond Strength of the Bulk-fill Composites, IJSR, Call for Papers, Online Journal
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064

Downloads: 113 | Views: 413

M.Tech / M.E / PhD Thesis | Dental Science | Turkiye | Volume 6 Issue 11, November 2017 | Rating: 6.4 / 10


Affect of the Different Irradiation Time and Light Density on the Shear Bond Strength of the Bulk-fill Composites

Caner Selami Guner, Faik Bulent Topbasi


Abstract: The objective of this study is in vitro examination of the dentin bonding values of bulk-fill composites under various light densities and irradiation times. Eighty-five extracted human molars were used. While Grandio (VOCO) was used in the control group, SDR (Dentsply), X-tra Base (VOCO), Quixfil (Dentsply) and X-tra Fil (VOCO) were used in the study groups. The bonding strength groups were divided based on the light density and irradiation time. The Max. Tensile values of control group were found statistically significantly higher than those of the study groups (p=0.042, p=0.005) and no statistically significant between the study goups (p=0.005).


Keywords: Dentin bonding, bulk-fill, dental composite, SDR, light density


Edition: Volume 6 Issue 11, November 2017,


Pages: 1223 - 1228



Rate this Article


Select Rating (Lowest: 1, Highest: 10)

5

Your Comments (Only high quality comments will be accepted.)

Characters: 0

Your Full Name:


Your Valid Email Address:


Verification Code will appear in 2 Seconds ... Wait

Top