International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 117 | Views: 215

Research Paper | Mechanical Engineering | India | Volume 4 Issue 1, January 2015


Optimization of End Milling Parameters on Surface Roughness of Die Steel HCHCr by Taguchi Method

M. S. Harne [3] | Ravikumar L. Shirsat


Abstract: - This paper outlines the Taguchi Optimization methodology, which is applied to optimize cutting parameters in end milling when machining Die steel (HCHCr D3). The milling parameters evaluated are cutting speed, feed rate and Depth of cut. An orthogonal Array, signal-to-noise (S/N) ratio and analysis of variance (ANOVA) are employed to analyze the effect of experiment (DOE), Mathematical model is generated by regression analysis. . Finally effect of process parameter on surface roughness (Ra) in end milling studied and optimum solution is carried out. The study shows that the taguchi method is suitable to solve the surface quality problem with minimum number of trials.


Keywords: Optimisation, End Milling, Taguchi Method, Surface Roughness, orthogonal Array, ANOVA


Edition: Volume 4 Issue 1, January 2015,


Pages: 2699 - 2702


How to Download this Article?

Type Your Valid Email Address below to Receive the Article PDF Link


Verification Code will appear in 2 Seconds ... Wait

Top