International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 105

India | Mechanical Engineering | Volume 3 Issue 11, November 2014 | Pages: 2865 - 2869


Dry Sliding Wear Behaviour of Al-Si-Ti Alloys Using Taguchi Method

Ganpat B. Jambukar, Dr. Y. R. Kharde

Abstract: The present study deals with investigation relating to the influence of wear parameters like sliding speed, applied load and sliding distance on the dry sliding wear of aluminium silicon titanium alloys. The design of experiment approach was employed to acquire data in controlled way using Taguchi method. A pin-on-disc apparatus was used to conduct the dry sliding wear test. An orthogonal array, signal-to-noise ratio and analysis of variance were employed to investigate the wear behavior of aluminium and its alloys. The mathematical model was obtained to determine the wear rate of the aluminium and its alloys. Addition of titanium in aluminium silicon alloys modifies microstructure as well improves the tribological characteristics.

Keywords: Al-Si-Ti Alloys, Wear, Orthogonal Array, ANOVA, Taguchi Method



Citation copied to Clipboard!
Jambukar, G. B., Kharde, &Y. R. (2014). Dry Sliding Wear Behaviour of Al-Si-Ti Alloys Using Taguchi Method. International Journal of Science and Research (IJSR), 3(11), 2865-2869. https://www.ijsr.net/getabstract.php?paperid=SUB1477 https://www.doi.org/10.21275/SUB1477

Rate this Article

5

Characters: 0

Received Comments

No approved comments available.

Rating submitted successfully!


Top