International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 1

Vietnam | Manufacturing Engineering | Volume 11 Issue 6, June 2022 | Pages: 1224 - 1227


Multi-Objective Optimization of Turning Parameters to Minimize Surface Roughness and Material Removal Rate Using TOPSIS Combining Entropy Weight

Nguyen Anh Thang, Truong Van Luong, Tran Van Hieu

Abstract: Product surface quality, including surface roughness, is the most important parameter to be achieved in machining. However, due to competitive pressure in the current global economy, in addition to ensuring the technical requirements of products, improving cutting productivity is also a goal that must be achieved at the same time. This paper presents a multi-objective optimization model to optimize the technological parameters in the hard turning of 9XC steel. The two objectives are the surface roughness Ra and material removal rate MRR are optimized simultaneously. The investigated technological parameters are cutting speed Vc, feed rate fz and depth of cut ap. The TOPSIS (Technique for Order Preference by Similarity to Ideal Solution) is applied to identify the optimal cutting parameters and the obtained results indicate that ap is the most significant factor followed by the fz and Vc.

Keywords: TOPSIS, Turning, Multi-Objective Optimization, Surface Roughness, Material Removal Rate



Citation copied to Clipboard!

Rate this Article

5

Characters: 0

Received Comments

No approved comments available.

Rating submitted successfully!


Top