International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 39

India | Mechatronic Engineering | Volume 10 Issue 3, March 2021 | Pages: 966 - 972


Automatic Error Correction in Optimized Technology for Blade De & Re-Erection

S. Anthonyraj Premkumar, R. Sathish, A. Vignesh, K. Thamodharan

Abstract: This paper describes the automatic error correction in the field of blade lowering and raising in a wind turbine where we already optimized the process of blade replacement using optimized technology [1] by eliminating the usage of heavy-duty cranes. By means of utilizing Ultrasonic, LiDAR, hall effect and loadcell sensor, we eliminate the chances for error in the operation of multiple winches simultaneously. Load shared by each winch can be identified using the loadcell sensor and provide feedback to the controller to correct the errors in the winch operation. Hall effect sensor is used to ensure that the winches are operating at proper pulses. The ultrasonic and LiDAR sensor is used to monitor the displacement of the blade while lowering and raising to protect the blade from the impact

Keywords: Ultrasonic, LiDAR, hall effect, loadcell sensor, Arduino



Citation copied to Clipboard!

Rate this Article

5

Characters: 0

Received Comments

No approved comments available.

Rating submitted successfully!


Top