International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 142

India | Mechanical Engineering | Volume 9 Issue 5, May 2020 | Pages: 543 - 546


3D Printer by Fused Deposition Modelling Method

V. M. Magar, Prasad Mapari, Rakesh Patel, Sumit Patil, Suraj Narkar

Abstract: 3d printing is a form of additive manufacturing where a 3-dimensional object is created by laying down successive layers of material. The main purpose of the research is to make a 3d printer with low cost and easy fabrication. Many industries use the traditional method for making prototype for analysis which is time consuming.3d printer can reduce this time and the cost but the initial cost of 3d printer in the Indian market is around 20, 000-30, 000Rs. So, in this research paper our aim is to develop a low-cost printer for commercial use.

Keywords: Additive manufacturing, 3D printing, Rapid Prototype, FDM



Rate This Article!



Received Comments

No approved comments available.


Top