International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064

Downloads: 110 | Views: 247

M.Tech / M.E / PhD Thesis | Mechanical Engineering | India | Volume 7 Issue 8, August 2018 | Rating: 6.6 / 10

Design, Modeling & Analysis of Helical Gear According to Bending Strength Using AGMA and FEMAP

Bhushan M. Modgekar | Dr. Kishor K. Dhande

Abstract: Gears are used to transmit the power. They can change torque, speed and direction of power source. While transmitting the power they are subjected to two main stresses i. e. bending stress and tooth contact stresses. These two stresses results in failure of the gear teeth, contact stress results in pitting failure at the contact surface and root bending stress results in fatigue fracture. In this paper bending stress is calculated by using analytical method for which AGMA standard (American Gear Manufacturing Association) is used and the model is designed in AUTODESK INVENTOR 2016 and saved in IGES format and then imported in the FEMAP with NASTRAN software where it can be analyzed. The main objective of this study to calculate bending stress and then compare results of both analytical and FEA approach.

Keywords: Helical gears, bending stress, AGMA standard, Autodesk Inventor, FEMAP with Nastran

Edition: Volume 7 Issue 8, August 2018,

Pages: 1650 - 1652

How to Download this Article?

Type Your Valid Email Address below to Receive the Article PDF Link

Verification Code will appear in 2 Seconds ... Wait