Review on Machining of Difficult to Cut Materials

Suvarna Patil

Abstract: Now a days industries are facing problems for cutting hard metals having hardness greater than50 HRC. Selecting a right process with optimum cost is a challenge for the industries. Lot of factors are affecting the process like tool material, different environments etc.

Keywords: hot machining, liquid, LAM, UAT

Edition: Volume 8 Issue 4, April 2019,

Pages: 817 - 819

How to Download this Article?

Type Your Valid Email Address below to Receive the Article PDF Link

Verification Code will appear in 2 Seconds ... Wait

Review on Machining of Difficult to Cut Materials

Similar Articles with Keyword 'liquid'

Design & Fabrication of Sanitizing Machine with Gate

Design of Medicine Refrigeration for Rural and Flood Affected Areas- Fast Chilling Solar Based Refrigerator with Dual Mode Battery Charging to Preserve Antitoxin for Treatment