International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 125

India | Mechanical Engineering | Volume 7 Issue 5, May 2018 | Pages: 1118 - 1127


Design Calculations, CAD Modelling and Analysis of Plastic Scrubber / Bullet Assembly Machine

Vineet Kadam

Abstract: This paper will discuss in detail the design procedure and simulation results of the plastic bullet assembly machine. This machine is manufactured so as to reduce the production time and cost, to enhance overall production, to reduce man power and man fatigue. The machine works on the principle of a simple press machine which uses compressed air for its operation. A chuck with an indexer is provides for the 1200 rotation of bullet while manufacturing. This has as a result increased precession and accuracy of the production.

Keywords: Chuck, adon block and rail, pneumatic cylinder, bullet/scrubber, DCV Tandem Centre, ANSYS, simulation



Citation copied to Clipboard!

Rate this Article

5

Characters: 0

Received Comments

No approved comments available.

Rating submitted successfully!


Top