International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 109 | Views: 212

Research Paper | Manufacturing Engineering | Iraq | Volume 7 Issue 1, January 2018 | Rating: 6.6 / 10


Milling Time Effective on Microstructure and Mechanical Properties of Al-Pb Alloy Produced by Mechanical Alloying

Adnan N. Abood | Nabeel K. Abid Alsahib | Suhair G. Hussien


Abstract: Aluminum lead alloys are considered as bearing materials of 21st century because of its lubricant behavior of Pb phase component. In present work, Al-Pb alloy was produced by mixing powders of (Al-10 %Pb-4.5 %Cu weight) using ball milling process with periods (two, six and ten hours), fine grain size, homogenous distribution of powder were achieved and noticed that a reduction of particle sizes with increasing milling time. Various testing processes were used concluded compression strength test, microstructure test included optical microscope, scanning electron microscope (SEM), energy dispersive x-ray spectra scope (EDX), and x-ray diffraction (XRD). Results of this part showed that the mixing time of two hours gave the best condition as compared with other two mixing times.


Keywords: Aluminum lead alloy, Mechanical alloying, Milling time, microstructure


Edition: Volume 7 Issue 1, January 2018,


Pages: 1937 - 1941


How to Download this Article?

Type Your Valid Email Address below to Receive the Article PDF Link


Verification Code will appear in 2 Seconds ... Wait

Top