International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 156

Mexico | Mechanical Engineering | Volume 6 Issue 11, November 2017 | Pages: 723 - 727


Mechanical Vibration Analysis on a Testing Bench using Visualization Software

Daniel F.R., Hector G.Y., J. Juan L.C., L. Favio D.C., Jonny C.R.

Abstract: The analysis of vibrations in the industrial sector is a very expensive technique. This article shows an analysis that may assist in the investigation of the development of low cost equipment for the detection of mechanical vibrations. The main objective is to analyze an analog signal sent by an accelerometer and by means of a data acquisition card observe that signal in a visualization software, this to detect faults in a roto-dynamic equipment. In the same way, three test methods were implemented in a testing bench one with balanced load, another with unbalanced load and in the last, the load was uncoupled to the motor shaft. These tests were performed to be able to interpret the generated signals in each case, thus establishing failure parameters in the testing bench motor.

Keywords: accelerometer, vibrations, analysis, visualization software, data acquisition card



Citation copied to Clipboard!

Rate this Article

5

Characters: 0

Received Comments

No approved comments available.

Rating submitted successfully!


Top