International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 134 | Views: 198 | Monthly Hits: ⮙1

Research Paper | Mechanical Engineering | India | Volume 2 Issue 7, July 2013 | Rating: 6.1 / 10


Wear of Reciprocating Screw for Injection Moulding Machine: A Review

Vikas. R. Rajoria | P. K. Jadhao


Abstract: Injection moulding machine is the most commonly used manufacturing process for the fabrication of plastic parts. The plastic being melted in injection molding machine and then injected into the mould. The barrel contains reciprocating screw for injecting the material into the mould and the material is also melted into the barrel. This paper presents the review of the causes of the wear of the screw and the barrel and their suggested solution


Keywords: Reciprocating, wear, Screw, Injection moulding machine


Edition: Volume 2 Issue 7, July 2013,


Pages: 292 - 295


How to Download this Article?

Type Your Valid Email Address below to Receive the Article PDF Link


Verification Code will appear in 2 Seconds ... Wait

Top