International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 125 | Views: 245

Research Paper | Mechanical Engineering | India | Volume 2 Issue 7, July 2013 | Popularity: 6.8 / 10


     

An Experimental Investigation of the Effect of Carbon Content on the Wear Behavior of Plain Carbon Steel

Amit K Gupta, Deep Narayan Mishra


Abstract: Wear behaviour of various carbon steels used in different industries has a direct impact on the performance of mechanical systems. In the present investigation the wear behaviour of carbon steels having varying carbon percentage has been studied, utilizing a pin-on disc sliding tribometer. Experiments were carried out under dry condition. Normal load applied was 5 25 N at a fixed rotational speed of 480 rpm. Results indicate that the wear performance of steel significantly governed by the chemical composition of material. Results have also shown that wear of carbon steel is markedly reduced by adding more carbon to it. Results obtained from experimental procedure shown by different graphs.


Keywords: carbon steel, friction, wear, pins on disc


Edition: Volume 2 Issue 7, July 2013


Pages: 222 - 224



Make Sure to Disable the Pop-Up Blocker of Web Browser




Text copied to Clipboard!
Amit K Gupta, Deep Narayan Mishra, "An Experimental Investigation of the Effect of Carbon Content on the Wear Behavior of Plain Carbon Steel", International Journal of Science and Research (IJSR), Volume 2 Issue 7, July 2013, pp. 222-224, https://www.ijsr.net/getabstract.php?paperid=02013119, DOI: https://www.doi.org/10.21275/02013119



Similar Articles

Downloads: 0

Research Paper, Mechanical Engineering, India, Volume 11 Issue 8, August 2022

Pages: 556 - 559

Effect of Pre Oxidation on Microstructure and Hardness of Low Carbon Steel during Nitrocarburising

Dr. Nirmala L.

Share this Article

Downloads: 1 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Research Paper, Mechanical Engineering, India, Volume 11 Issue 6, June 2022

Pages: 817 - 826

Heat Transfer Enhancement through Perforated Fin Made by Al-SiC-MMC and Optimization of Design Parameters using Taguchi DOE Method

A. Kalyan Charan, Dr. R. Uday Kumar, Dr. B. Balunaik

Share this Article

Downloads: 1 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Analysis Study Research Paper, Mechanical Engineering, India, Volume 11 Issue 7, July 2022

Pages: 1884 - 1887

Simulation Study of Material Behavior and Optimization of Die Angle in Indirect Extrusion Process using AFDEX Software

Anand C Sedamkar, Bharat S Kodli

Share this Article

Downloads: 1 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Research Paper, Mechanical Engineering, India, Volume 3 Issue 6, June 2014

Pages: 2846 - 2847

Experimental Investigation of Different Material Surface Morphology on Formation of Transfer Layer

M. Basavaraju, Maharudra

Share this Article

Downloads: 1 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Research Paper, Mechanical Engineering, China, Volume 13 Issue 4, April 2024

Pages: 1173 - 1180

An Elastoplastic Model Simulation to Investigate the Bending Load on Lattice Structures

Reza Shamim

Share this Article
Top