International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 106

Research Paper | Production Engineering | India | Volume 4 Issue 5, May 2015


Influence of Process Parameters on Depth of Penetration in GMAW Process by Using Taguchi Method

S. D. Ambekar [2] | Sunil R. Wadhokar


Abstract: This study is to investigate the influence of process parameters on depth of penetration in Gas metal arc welding (GMAW) process. The optimization for Gas metal arc welding process parameters of Martensitic Stainless steel work piece AISI 410 using Taguchi method is carried out. Sixteen experimental runs (L16) based on an orthogonal array Taguchi method were performed. This paper presents the effect of welding parameters like welding speed, welding current and wire diameter on penetration. The ANOVA and signal to noise ratio (S/N ratio) is applied to identify the most significant factor and predicted optimal parameter setting. Experiment with the optimized parameter setting, which have been obtained from the analysis, are giving valid the results. The confirmation test is conducted and found the results closer to the optimize results. These results showed the successful implementation of methodology.


Keywords: Gas metal arc welding, welding parameters, penetration, signal to noise ratio, orthogonal array


Edition: Volume 4 Issue 5, May 2015,


Pages: 3065 - 3069


How to Download this Article?

You Need to Register Your Email Address Before You Can Download the Article PDF


How to Cite this Article?

S. D. Ambekar, Sunil R. Wadhokar, "Influence of Process Parameters on Depth of Penetration in GMAW Process by Using Taguchi Method", International Journal of Science and Research (IJSR), Volume 4 Issue 5, May 2015, pp. 3065-3069, https://www.ijsr.net/get_abstract.php?paper_id=SUB155031

Similar Articles with Keyword 'welding parameters'

Downloads: 97 | Monthly Hits: ⮙1

Research Paper, Production Engineering, India, Volume 3 Issue 6, June 2014

Pages: 2721 - 2726

Application of Taguchi Method for Resistance Spot Welding of Stainless Steel-304 Grade

Manjunath R. Rawal | Dr. K. H. Inamdar [6]

Share this Article

Downloads: 99

Review Papers, Production Engineering, India, Volume 4 Issue 4, April 2015

Pages: 3032 - 3034

A Review on Effect of Various Process Parameters on Weld Joint of Dissimilar & Similar Metals in Tig Welding

M. S. Harne [3] | S. S. Sathe [2]

Share this Article
Top