International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 115

Review Papers | Mechanical Engineering | India | Volume 5 Issue 4, April 2016


Oil Cooler Selection for Hydraulic System of Plastic Injection Moulding Machine: A Review

Sandip Kumar Das [2] | Kedar Bhojak [4]


Abstract: The effect of oil temperature of the hydraulic system for Plastic Injection Moulding Machine is studied in this paper. Traditionally in India the hydraulic oil VG-68 for Plastic Injection Moulding Machine is used, which has an optimum temperature range with desired effective viscosity property is between 40C to 50C. The oil temperature goes high up to 55c and even higher than that during summer, which is not desirable for the machine operations. It is found that the operation of the machine will get sluggish as the oil viscosity get decreases. This is due to continuous flow and heavy production schedule. The oil needs to be cooled down as fast as possible from the elevated temperature to required temperature. So it is very important to choose the correct type and size of oil cooler for hydraulic system.


Keywords: Hydraulic system, VG-68, Plastic Injection Moulding Machine, Viscosity Grade oil, Heat Transfer Rate Increments, oil cooler


Edition: Volume 5 Issue 4, April 2016,


Pages: 2266 - 2271


How to Download this Article?

You Need to Register Your Email Address Before You Can Download the Article PDF


How to Cite this Article?

Sandip Kumar Das, Kedar Bhojak, "Oil Cooler Selection for Hydraulic System of Plastic Injection Moulding Machine: A Review", International Journal of Science and Research (IJSR), Volume 5 Issue 4, April 2016, pp. 2266-2271, https://www.ijsr.net/get_abstract.php?paper_id=NOV163211

Similar Articles with Keyword 'Hydraulic system'

Downloads: 115

Review Papers, Mechanical Engineering, India, Volume 5 Issue 4, April 2016

Pages: 1457 - 1461

A Review on Possible Increment of Heat Transfer Rate for Hydraulic Oil Used in Plastic Injection Moulding Machine

Sandip Kumar Das [2] | Kedar Bhojak [4]

Share this Article

Downloads: 131

Research Paper, Mechanical Engineering, India, Volume 9 Issue 7, July 2020

Pages: 1092 - 1093

Design of 20 Ton Hydraulic Press Machine for Flaring Operation

Viraj B. Ghangale

Share this Article
Top