Downloads: 109
Research Paper | Manufacturing Engineering | Iraq | Volume 7 Issue 1, January 2018
Milling Time Effective on Microstructure and Mechanical Properties of Al-Pb Alloy Produced by Mechanical Alloying
Adnan N. Abood | Nabeel K. Abid Alsahib | Suhair G. Hussien
Abstract: Aluminum lead alloys are considered as bearing materials of 21st century because of its lubricant behavior of Pb phase component. In present work, Al-Pb alloy was produced by mixing powders of (Al-10 %Pb-4.5 %Cu weight) using ball milling process with periods (two, six and ten hours), fine grain size, homogenous distribution of powder were achieved and noticed that a reduction of particle sizes with increasing milling time. Various testing processes were used concluded compression strength test, microstructure test included optical microscope, scanning electron microscope (SEM), energy dispersive x-ray spectra scope (EDX), and x-ray diffraction (XRD). Results of this part showed that the mixing time of two hours gave the best condition as compared with other two mixing times.
Keywords: Aluminum lead alloy, Mechanical alloying, Milling time, microstructure
Edition: Volume 7 Issue 1, January 2018,
Pages: 1937 - 1941
Similar Articles with Keyword 'microstructure'
Downloads: 101
M.Tech / M.E / PhD Thesis, Manufacturing Engineering, India, Volume 3 Issue 7, July 2014
Pages: 1414 - 1418Friction Stir Surfacing of Copper
Malkeshwar Vinod Kumar | Dr. S. V. Satish [3]
Downloads: 113
Research Paper, Manufacturing Engineering, India, Volume 8 Issue 6, June 2019
Pages: 1855 - 1861Prediction of Residual Stresses, Distortions and Microstructure in Effect of Various Welding Processes: A Review
A Pradeep Samuel | Nandu Mohan