International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Fully Refereed | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064


Downloads: 118

Research Paper | Mechanical Engineering | India | Volume 3 Issue 6, June 2014


Parametric Optimization of Metal Inert Gas Welding and Tungsten Inert Gas Welding By Using Analysis of Variance and Grey Relational Analysis

Jay Joshi [5] | Manthan Thakkar [2] | Sahil Vora


Abstract: Metal Inert Gas (MIG) welding and Tungsten Inert Gas (TIG) are one of the widely used techniques for joining ferrous and non-ferrous metals. In this experiment Design of Experiment method was used. For this work with use of the experimental data; optimization done by the grey relational analysis (GRA) technique; in which input parameters for MIG welding are welding current; gas flow and wire feed rate and the output parameter is tensile strength. Also the input parameters for TIG welding are welding current; gas flow and the output parameter is tensile strength. Aluminum used as base material for welding. For Experimental design full factorial method was used (L=m) to find out number of readings. To find out percentage contribution of each input parameters for obtaining optimal conditions; Analysis of variance (ANOVA) method was used. The grey relational grade obtained with use of grey relational analysis technique. By analyzing the Grey relational grade the optimum parameters were evaluated.


Keywords: ANOVA, Grey relational analysis, Tensile Strength, MIG Welding, TIG Welding


Edition: Volume 3 Issue 6, June 2014,


Pages: 1099 - 1103


How to Download this Article?

You Need to Register Your Email Address Before You Can Download the Article PDF


How to Cite this Article?

Jay Joshi, Manthan Thakkar, Sahil Vora, "Parametric Optimization of Metal Inert Gas Welding and Tungsten Inert Gas Welding By Using Analysis of Variance and Grey Relational Analysis", International Journal of Science and Research (IJSR), Volume 3 Issue 6, June 2014, pp. 1099-1103, https://www.ijsr.net/get_abstract.php?paper_id=2014405

Similar Articles with Keyword 'ANOVA'

Downloads: 105

Research Paper, Mechanical Engineering, India, Volume 3 Issue 11, November 2014

Pages: 2865 - 2869

Dry Sliding Wear Behaviour of Al-Si-Ti Alloys Using Taguchi Method

Ganpat B. Jambukar | Dr. Y. R. Kharde

Share this Article

Downloads: 117

Research Paper, Mechanical Engineering, India, Volume 4 Issue 1, January 2015

Pages: 2699 - 2702

Optimization of End Milling Parameters on Surface Roughness of Die Steel HCHCr by Taguchi Method

M. S. Harne [3] | Ravikumar L. Shirsat

Share this Article
Top