Design for Low Power Multiplier Based On Fixed Width Replica Redundancy Block & Compressor Trees
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
www.ijsr.net | Open Access | Fully Refereed | Peer Reviewed International Journal

ISSN: 2319-7064

Downloads: 111 | Weekly Hits: ⮙2 | Monthly Hits: ⮙12

M.Tech / M.E / PhD Thesis | Electronics & Communication Engineering | India | Volume 4 Issue 10, October 2015

Design for Low Power Multiplier Based On Fixed Width Replica Redundancy Block & Compressor Trees

Mariya Stephen, Vrinda

This paper establishes designing multipliers that are of high-speed, low power, and regular in layout are of substantial research interest. Multiplier speed can be increased by reducing the generated partial products. Many attempts are done to reduce the number of partial products generated in a multiplication process. One of them is Wallace tree multiplier. Wallace Tree CSA structures are used to sum the partial products in reduced time. Speed can be increased by incorporating compressors with wallace tree technique. Therefore, minimizing the number of half adders used in a multiplier which will reduce the circuit complexity.

Keywords: Carry save adders CSA

Edition: Volume 4 Issue 10, October 2015

Pages: 1069 - 1074

Share this Article

How to Cite this Article?

Mariya Stephen, Vrinda, "Design for Low Power Multiplier Based On Fixed Width Replica Redundancy Block & Compressor Trees", International Journal of Science and Research (IJSR), https://www.ijsr.net/search_index_results_paperid.php?id=SUB158885, Volume 4 Issue 10, October 2015, 1069 - 1074

Enter Your Registered Email Address







Top