To Reduce Timer Plate Leakage in VE-Mechanical Pumps Using SPC Techniques
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
www.ijsr.net | Open Access | Fully Refereed | Peer Reviewed International Journal

ISSN: 2319-7064



Downloads: 111

Research Paper | Production Engineering | India | Volume 4 Issue 9, September 2015

To Reduce Timer Plate Leakage in VE-Mechanical Pumps Using SPC Techniques

Samandar Singh, Devi Singh Kumani

Six sigma methodologies DMAIC is very important statical process control technique regarding process improvement, control and productivity improvement in manufacturing industries. In an existing manufacturing process DMAIC, Root cause analysis and ISHIKAWA diagrams are powerful techniques to find out the actual causes which are reducing the productivity. During scrutiny of assembly process of VE- pumps critical parameters, which have major impact on productivity and quality were identified by using ISHIKAWA diagram and actual causes of leakage were resolved by root cause analysis. Thus process can be improved and controlled on the basis of SPC techniques. This paper focusing on the DMAIC technique used to improving the existing handing method at BOSCH, Jaipur plant in the assembly of VE-fuel injection pumps. This paper also integrates with implantation of six sigma to define the maximum safe no. of cycles for test timer plates-312.

Keywords: DMAIC, DMADV, SPC Techniques, VE-pump, etc

Edition: Volume 4 Issue 9, September 2015

Pages: 869 - 875

Share this Article

How to Cite this Article?

Samandar Singh, Devi Singh Kumani, "To Reduce Timer Plate Leakage in VE-Mechanical Pumps Using SPC Techniques", International Journal of Science and Research (IJSR), https://www.ijsr.net/search_index_results_paperid.php?id=SUB158157, Volume 4 Issue 9, September 2015, 869 - 875

Enter Your Email Address




Similar Articles with Keyword 'etc'

Downloads: 95

Research Paper, Production Engineering, India, Volume 6 Issue 3, March 2017

Pages: 2329 - 2335

Effect and Optimization of Process Parameters using Taguchi Method in WEDM for AISI M42 HSS Material

Joshi Guruprasad R., Dr. A. N. Chapgaon

Share this Article

Downloads: 107

Research Paper, Production Engineering, India, Volume 3 Issue 6, June 2014

Pages: 2637 - 2641

Analysis of Load Test Fixture Acting Under Static Loading Condition

Vineet V. Gosavi, Dr. K. H. Inamdar

Share this Article



Top