Design and Fabrication of Plate Thermometer for the Measurement of Incident Radiation Heat Flux on a Surface
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
www.ijsr.net | Open Access | Fully Refereed | Peer Reviewed International Journal

ISSN: 2319-7064

Research Paper | Mechanical Engineering | India | Volume 4 Issue 8, August 2015

Design and Fabrication of Plate Thermometer for the Measurement of Incident Radiation Heat Flux on a Surface

Aditya Priyadarshi, Ankit

This paper deals with the heat transfer mechanisms in a furnace, and explains the use of a plate thermometer to measure the incident radiation heat flux at a point, replacing conventional heat flux meters.

Keywords: Heat transfer, radiation, Heat flux meters, conduction correlation factor, plate thermometer

Edition: Volume 4 Issue 8, August 2015

Pages: 1460 - 1465

Share this Article

How to Cite this Article?

Aditya Priyadarshi, Ankit, "Design and Fabrication of Plate Thermometer for the Measurement of Incident Radiation Heat Flux on a Surface", International Journal of Science and Research (IJSR), https://www.ijsr.net/search_index_results_paperid.php?id=SUB157687, Volume 4 Issue 8, August 2015, 1460 - 1465

136 PDF Views | 107 PDF Downloads

Download Article PDF



Similar Articles with Keyword 'Heat transfer'

Research Paper, Mechanical Engineering, India, Volume 4 Issue 5, May 2015

Pages: 2857 - 2861

Analysis of Heat Transfer in Turbulent Channel Using Grooves

Mayank Bhola, Dr. Satyendra Singh

Share this Article

Research Paper, Mechanical Engineering, India, Volume 9 Issue 7, July 2020

Pages: 676 - 682

Increasing Heat Exchanger Performance

Nikhanj Ratan

Share this Article

Research Paper, Mechanical Engineering, India, Volume 4 Issue 8, August 2015

Pages: 990 - 993

Parametric Comparison of Heat Transfer in Helical and Straight Tube-In-Tube Heat Exchanger

Suraj R. Gurav

Share this Article

Research Paper, Mechanical Engineering, India, Volume 4 Issue 4, April 2015

Pages: 2188 - 2192

Experimental Analysis on Effect of Design Parameters on the Performance of Single Loop Pulsating Heat Pipe

Someshwar S. Bhakre, Md. Rafik Sajjadahmad Choudhari

Share this Article

Research Paper, Mechanical Engineering, India, Volume 4 Issue 12, December 2015

Pages: 2024 - 2027

Thermal Analysis of Pin Fin using Different Materials and Forms

Laxmikant Chavan, Niranjan Purane

Share this Article

Similar Articles with Keyword 'radiation'

Research Paper, Mechanical Engineering, India, Volume 4 Issue 8, August 2015

Pages: 1460 - 1465

Design and Fabrication of Plate Thermometer for the Measurement of Incident Radiation Heat Flux on a Surface

Aditya Priyadarshi, Ankit

Share this Article

Research Paper, Mechanical Engineering, India, Volume 5 Issue 2, February 2016

Pages: 1706 - 1710

Comparative Study of Heat Absorbing Packed Bed Regenerator for Space Heating Using Clay And Waste Hard Rubber for Long Term Heat Storage

Shivasheesh Kaushik, Dr. Anirudh Gupta

Share this Article

Research Paper, Mechanical Engineering, India, Volume 4 Issue 4, April 2015

Pages: 1236 - 1238

Comparative Study of Heat Transfer Rate between General Water and Distilled Water

Rahul R. Puri, Nikhil C. Parhad, Dharmendra Kumar, Ashish Charjan, Nikhil Ambade, Prof. Ritesh K. Sambare

Share this Article

Research Paper, Mechanical Engineering, Iraq, Volume 3 Issue 8, August 2014

Pages: 945 - 949

Estimation and Simulation of Solar Radiation in Certain Iraqi Governorates

Dr. Abdullateef A. Jadallah, Dr. Dhari Y. Mahmood, Zaid A. Abdulqader

Share this Article

Research Paper, Mechanical Engineering, India, Volume 4 Issue 5, May 2015

Pages: 3198 - 3205

Experimental Study of Heat Absorbing Packed Bed Regenerator for Space Heating for Industrial Purpose

Shivasheesh Kaushik, Dr. Anirudh Gupta

Share this Article
Top