International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Since Year 2012 | Open Access | Fully Refereed | Peer Reviewed

ISSN: 2319-7064




Downloads: 177

Research Paper | Mechanical Engineering | India | Volume 9 Issue 3, March 2020


Use of Vegetable Oil as Cutting Fluid in Turning of Mild Steel with MQL and Optimization of Cutting Parameter

Bramhane R S | Pawar D S


Abstract: Cutting fluids are mainly used in machining process as coolant to reduce the temperature at cutting zone and for the lubrication to avoid the friction between the work piece and tool. The current research involves the performance analysis in turning M. S bar in flood and MQL cutting scenario. Most of the industrial application mineral oil use as cutting fluid. the use of mineral oil is hazards to living condition. cutting fluid which are used in industry today is toxic and costly unhealthy for worker and environment. damping of cutting oil is most problematic subject to the industry. Denigration of cutting fluid also lead to economical advantage of saving recycling of cutting fluid, corrosion and erosion of work piece. In this project vegetable oil used as cutting fluid and effect on cutting forces, surface roughness and temperature of work piece is analyses with application of minimum quantity lubrication system. flow rate of mql kept 50 ml and flow rate for flood cooling 500 ml. Low budget carbide tipped single point cutting tool is used. optimize the cutting parameter with help RSM


Keywords: MQL, cutting performance, turning, and carbide insert, vegetable oil


Edition: Volume 9 Issue 3, March 2020,


Pages: 1186 - 1190


How to Cite this Article?

Bramhane R S, Pawar D S, "Use of Vegetable Oil as Cutting Fluid in Turning of Mild Steel with MQL and Optimization of Cutting Parameter", International Journal of Science and Research (IJSR), Volume 9 Issue 3, March 2020, pp. 1186-1190, https://www.ijsr.net/get_abstract.php?paper_id=SR20318165622

How to Share this Article?

Enter Your Email Address




Similar Articles with Keyword 'turning'

Downloads: 112

Research Paper, Mechanical Engineering, Indonesia, Volume 8 Issue 9, September 2019

Pages: 1457 - 1459

Optimization Analysis of Turning Process Parameters for Shaft Characteristics

F Rahmadianto | Totok Soegiarto | Soeparno Djiwo

Share this Article

Downloads: 115

Research Paper, Mechanical Engineering, India, Volume 3 Issue 6, June 2014

Pages: 2651 - 2653

Analysis of Pedal Operated Wheel Brake System of a Helicopter Using Adams Software

Dr. Yadavalli Basavaraj [2] | Pavan Kumar B. K | Gourishankar Hiremath [2]

Share this Article


Top