Downloads: 113 | Views: 127
M.Tech / M.E / PhD Thesis | Electronics & Communication Engineering | India | Volume 3 Issue 11, November 2014
A CAN Bus Based System for Monitoring and Fault Diagnosis in Wind Turbine
R. Selvamuthukumaran | P. Vimal Kumar
Abstract: A CAN based architecture is designed for the purpose of intensive monitoring and fault diagnosis in wind turbine. It provides a full automation system. CAN (Controller Area Network) Bus is a high speed serial data bus with high transmission rate. CAN Bus interface technique with an integration of electro-mechanical subsystems that embeds network control systems is proposed along with ARM controller to monitor and diagnose the problems in the wind turbine application. CAN BUS will enable the data transmission between two units at the same time without any disturbances. The data transmission time is increased with this CAN protocol. ARM core1 runs with CAN and LPC2148 as wind turbine unit to which sensors are connected and ARM core2 as Fault diagnose and monitoring section. A discussion about weather condition (WC) monitoring and generation voltage (GV) display is also added in this design. Data acquisition node collects the sensor data through CAN protocol. This technique reduces the possibility of fault and increase the monitoring of wind turbine.
Keywords: CAN BUS, FAULT DETECTION, DIAGNOSIS, WIND TURBINE, AUTOMATION
Edition: Volume 3 Issue 11, November 2014,
Pages: 2237 - 2239
Similar Articles with Keyword 'CAN BUS'
Downloads: 113
Research Paper, Electronics & Communication Engineering, India, Volume 4 Issue 5, May 2015
Pages: 2578 - 2579A CAN Bus Based System for Monitoring and Fault Diagnosis in Wind Turbine
Solankar Rajaram | Ambilpure Prasad
Downloads: 121
Research Paper, Electronics & Communication Engineering, India, Volume 2 Issue 8, August 2013
Pages: 272 - 274Controller Area Network for Monitoring and Controlling the Industrial Parameters Using Bluetooth Communication
B. Praveen Kumar | B. Bhavani [3]