The Determination of Minimum Bubbling Velocity, Minimum Fluidization Velocity and Fluidization Index of Fine Powders (Hematite) using Gas-Solid Tapered Beds
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
www.ijsr.net | Open Access | Fully Refereed | Peer Reviewed International Journal

ISSN: 2319-7064



Research Paper | Chemical Engineering | India | Volume 2 Issue 2, February 2013

The Determination of Minimum Bubbling Velocity, Minimum Fluidization Velocity and Fluidization Index of Fine Powders (Hematite) using Gas-Solid Tapered Beds

Deo Karan Ram

In this report the experimental determination of maximum pressure drop, minimum fluidization velocity, and minimum bubbling velocity and Fluidization index of fine Hematite powder has been done. A tapered bed having a tapered angle of 7.40 has been used in this study. Tapered beds have a velocity gradient along the axis unlike conventional beds. They have been used as an alternative to conventional cylindrical beds to deal with problems such as slugging. In this study pressure drop was measured using a U tube Manometer). Air at ambient conditions (310 K) was used as the fluidizing medium. The air flow rates were measured using a rotameter. Initially stagnant bed height of 5.5 cm was taken. The superficial velocity (Air flow rate/area) of the air passed from below the distributor was increased in small increments. The corresponding manometer readings were noted down. Pressure drop at the corresponding superficial velocity was calculated from the height difference between two arms of the manometer. The Superficial velocity at which maximum pressure drop was obtained was noted as the minimum fluidization velocity. At the onset of fluidization bubbles appeared and the superficial velocity at which the first bubbles appeared was taken as the minimum bubbling velocity. The fluidization index is the ratio of minimum bubbling velocity to the minimum fluidization velocity. Geldart in his works had shown that fluidization index is a very useful criterion to determine the hydrodynamic behavior of fine powders. The effect of variation of the tapered bed height on maximum pressure drop, minimum fluidization velocity, minimum bubbling velocity and fluidization index were studied by repeating the tests mentioned above for stagnant bed heights of 10cm and 15 cm.

Keywords: Gas solid fluidization, Minimum fluidization velocity, minimum bubbling velocity, Maximum pressure drop, Tapered fluidized bed

Edition: Volume 2 Issue 2, February 2013

Pages: 287 - 293

Share this Article

How to Cite this Article?

Deo Karan Ram, "The Determination of Minimum Bubbling Velocity, Minimum Fluidization Velocity and Fluidization Index of Fine Powders (Hematite) using Gas-Solid Tapered Beds", International Journal of Science and Research (IJSR), https://www.ijsr.net/search_index_results_paperid.php?id=IJSR13010186, Volume 2 Issue 2, February 2013, 287 - 293

60 PDF Views | 55 PDF Downloads

Download Article PDF



Similar Articles with Keyword 'Minimum fluidization velocity'

Research Paper, Chemical Engineering, India, Volume 2 Issue 2, February 2013

Pages: 287 - 293

The Determination of Minimum Bubbling Velocity, Minimum Fluidization Velocity and Fluidization Index of Fine Powders (Hematite) using Gas-Solid Tapered Beds

Deo Karan Ram

Share this Article

Research Paper, Chemical Engineering, India, Volume 7 Issue 12, December 2018

Pages: 568 - 573

Experimental Investigations on Variation in Static Bed Height and Particle Size on Pressure Drop and Bed Expansion Ratio in Three Phase Fluidized Bed

P. Sreedhar, P. Akhila Swathanthra, Ch. V. Naga Sowjanya

Share this Article

Research Paper, Chemical Engineering, India, Volume 5 Issue 2, February 2016

Pages: 2049 - 2054

Hydrodynamic Studies on Conventional and Tapered Fluidized Bed

Deo Karan Ram, Alok Tiwari

Share this Article

Similar Articles with Keyword 'minimum bubbling velocity'

Research Paper, Chemical Engineering, India, Volume 2 Issue 2, February 2013

Pages: 287 - 293

The Determination of Minimum Bubbling Velocity, Minimum Fluidization Velocity and Fluidization Index of Fine Powders (Hematite) using Gas-Solid Tapered Beds

Deo Karan Ram

Share this Article

Research Paper, Chemical Engineering, India, Volume 5 Issue 2, February 2016

Pages: 2049 - 2054

Hydrodynamic Studies on Conventional and Tapered Fluidized Bed

Deo Karan Ram, Alok Tiwari

Share this Article

Similar Articles with Keyword 'Maximum pressure drop'

Research Paper, Chemical Engineering, India, Volume 2 Issue 2, February 2013

Pages: 287 - 293

The Determination of Minimum Bubbling Velocity, Minimum Fluidization Velocity and Fluidization Index of Fine Powders (Hematite) using Gas-Solid Tapered Beds

Deo Karan Ram

Share this Article

Research Paper, Chemical Engineering, India, Volume 5 Issue 2, February 2016

Pages: 2049 - 2054

Hydrodynamic Studies on Conventional and Tapered Fluidized Bed

Deo Karan Ram, Alok Tiwari

Share this Article

Similar Articles with Keyword 'Tapered fluidized bed'

Research Paper, Chemical Engineering, India, Volume 5 Issue 2, February 2016

Pages: 1632 - 1635

The Study of Grains Drying in Tapered Fluidized Bed

Deo Karan Ram, Alok Tiwari

Share this Article

Research Paper, Chemical Engineering, India, Volume 2 Issue 2, February 2013

Pages: 287 - 293

The Determination of Minimum Bubbling Velocity, Minimum Fluidization Velocity and Fluidization Index of Fine Powders (Hematite) using Gas-Solid Tapered Beds

Deo Karan Ram

Share this Article

Research Paper, Chemical Engineering, India, Volume 5 Issue 2, February 2016

Pages: 2049 - 2054

Hydrodynamic Studies on Conventional and Tapered Fluidized Bed

Deo Karan Ram, Alok Tiwari

Share this Article
Top