International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Since Year 2012 | Open Access | Fully Refereed | Peer Reviewed

ISSN: 2319-7064

Downloads: 124

Research Paper | Automobiles | India | Volume 8 Issue 6, June 2019

Design & Optimization of Roll Cage

Mohana Chouhan [3] | Kamlesh Gangrade [3] | Suman Sharma [18]

Abstract: The primary target of this paper is to optimize the plan of a recentroll cage structure for SAE standard based famous Atv vehicle. inthis undertaking work, different factors, for example factor of safety, distortion, von-misses pressure, work estimate dependency of produced pressure and effect constrained are considered. A small portion vehicle is a small, rough terrain vehicle fueled by a four stroke motor, along these lines large part of vehicle execution relies upon speeding up which is corresponding to the heaviness of the vehicle and consequently frame. To accomplish more noteworthy execution of the vehicle, a parity must be found among quality and weight of the roll cage to guarantee safety of the driver. so roll cage part of the case is the essential assurance for the driver. the structure improvement of Roll Cage which depends on position, area and direction of connection. Henceforth a multibody dynamic examination is completed to think about execution of Roll Cage. Demonstrating was done to convey the mass of the vehicle over it's casing individuals to recreate this present reality issue for dynamic investigation. The learning intends to configuration, investigate and discover material for a roll cage of an ATV as per the rulebook ofSAE BAJA 2018. SAE BAJA is an off-road vehicle rivalry which gives under aalumni understudy a viable involvement in building engineering sciences. it manages displaying of Roll Cage of car (SAE BAJA) and examining it to give an ideal plan. The roll cage must be built of steel tubing, with least dimensional and quality necessity managed by society of automotive Engineers (SAE).

Keywords: Roll cage, BAJA, ATV, Solid Work, ANSYS CFD

Edition: Volume 8 Issue 6, June 2019,

Pages: 2068 - 2069

How to Cite this Article?

Mohana Chouhan, Kamlesh Gangrade, Suman Sharma, "Design & Optimization of Roll Cage", International Journal of Science and Research (IJSR), Volume 8 Issue 6, June 2019, pp. 2068-2069,

How to Share this Article?

Enter Your Email Address

Similar Articles with Keyword 'Roll'

Downloads: 2

Student Project, Automobiles, India, Volume 10 Issue 5, May 2021

Pages: 1227 - 1231

Smart Car System

Shriya Chavan | Neerav Thakur | Mayuresh Pandit | Meet Sangoi | Neeta Chavan

Share this Article

Downloads: 2

Review Papers, Automobiles, India, Volume 10 Issue 8, August 2021

Pages: 807 - 810

Automatic Braking System with Pneumatic Bumper for Vehicles

Chaitanya Pandya

Share this Article