Drag Reduction: Design & Analysis of Vortex Generator
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
www.ijsr.net | Open Access | Fully Refereed | Peer Reviewed International Journal

ISSN: 2319-7064

Downloads: 146

Research Paper | Mechanical Engineering | India | Volume 8 Issue 1, January 2019

Drag Reduction: Design & Analysis of Vortex Generator

Ashish Domal, VinayAhuja, Pankaj Ande

In initial flow simulation, Audi a4 car model is imported in CHAM PHOENICS- CFD software and tested under different speeds, then airflow, pressure and velocity value are analysed. After that in modified flow simulation, vortex generators are carefully designed and installed at the rear end of the vehicle and same cycle is repeated. After getting results from both the flow simulations, differences in aerodynamics characteristics are studied. Drag forces are calculated in both initial and modified flow simulations, to understand the effect of vortex generator i. e. to check whether drag of the vehicle is reduced or not after installing vortex generator, as ultimate aim of the vortex generator is to reduce drag properties at the rear end of the car by reducing flow separation and turbulence of air.

Keywords: CHAM Phoenics- CFD, Vortex generator, Drag force, Flow separations, PTC Creo- CAD

Edition: Volume 8 Issue 1, January 2019

Pages: 1634 - 1641

Share this Article

How to Cite this Article?

Ashish Domal, VinayAhuja, Pankaj Ande, "Drag Reduction: Design & Analysis of Vortex Generator", International Journal of Science and Research (IJSR), https://www.ijsr.net/search_index_results_paperid.php?id=ART20194655, Volume 8 Issue 1, January 2019, 1634 - 1641

Enter Your Email Address




Similar Articles with Keyword 'Vortex generator'

Downloads: 107 | Weekly Hits: ⮙1 | Monthly Hits: ⮙11

Research Paper, Mechanical Engineering, Iraq, Volume 3 Issue 11, November 2014

Pages: 2032 - 2040

Numerical Study of Fluid Flow and Heat Transfer over a Circular Tubes Bank of Heat Exchanger with Different Shapes of Vortex Generator

Ahmed Khafeef Obaid Albdoor

Share this Article

Downloads: 117 | Weekly Hits: ⮙1 | Monthly Hits: ⮙16

Comparative Studies, Mechanical Engineering, India, Volume 6 Issue 3, March 2017

Pages: 1303 - 1305

Experimental Analysis of Hybrid Vortex Cooling System

Neeta P Mathurvaishya, Sameer Y. Bhosale

Share this Article

Downloads: 146

Research Paper, Mechanical Engineering, India, Volume 8 Issue 1, January 2019

Pages: 1634 - 1641

Drag Reduction: Design & Analysis of Vortex Generator

Ashish Domal, VinayAhuja, Pankaj Ande

Share this Article

Downloads: 185

Review Papers, Mechanical Engineering, Iraq, Volume 3 Issue 12, December 2014

Pages: 363 - 367

Heat Transfer Enhancement and Fluid Flow across Tube Banks Heat Exchanger with Passive Control Technique by Using Vortex Generator (A Review)

Mohammed Saad Kamel

Share this Article

Similar Articles with Keyword 'Drag force'

Downloads: 129 | Weekly Hits: ⮙2

Research Paper, Mechanical Engineering, India, Volume 6 Issue 8, August 2017

Pages: 539 - 544

Investigation into Effect of Rotor RPM on Degree of Separation in Air Classifier

Netra R. Lagad, Sainand M. Jadhav

Share this Article

Downloads: 131

M.Tech / M.E / PhD Thesis, Mechanical Engineering, India, Volume 4 Issue 9, September 2015

Pages: 1298 - 1305

Investigation of Drag and Lift Forces over the Profile of Car with Rearspoiler Using CFD

V. Naveen Kumar, Dr. K. Lalit Narayan, L. N. V. Narasimha Rao, Y. Sri Ram

Share this Article

Downloads: 146

Research Paper, Mechanical Engineering, India, Volume 8 Issue 1, January 2019

Pages: 1634 - 1641

Drag Reduction: Design & Analysis of Vortex Generator

Ashish Domal, VinayAhuja, Pankaj Ande

Share this Article

Downloads: 149

Review Papers, Mechanical Engineering, India, Volume 3 Issue 6, June 2014

Pages: 213 - 215

CFD Analysis of Aerodynamic Drag Reduction of Automobile Car - A Review

Jaspinder Singh, Jagjit Singh Randhawa

Share this Article



Top