International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Open Access | Fully Refereed | Peer Reviewed

ISSN: 2319-7064




Downloads: 111

Review Papers | Manufacturing Engineering | India | Volume 6 Issue 5, May 2017


Review on Optimization Process Parameters of HCHCR, OHNS, EN24 Materials

Dnyaneshwar. B. Unawane, K. J. Godihal


Abstract: Cubic boron nitride ( CBN) is the second hardest material in the material. Diamond is the only hardest material & its natural material. CBN is actually a powder which is coated on the caeamics/ carbide inserts, in that the binder materials are titanium, so the there is huge area to work on the tool life of CBN inserts, because it is costlier than tungsten carbide & other insert materials. The hard-turning process is steadily finding its place in modern manufacturing technology and with advance cutting tool materials it can be applied as another machining process to turning providing a more economical way to finish hard surfaces. The main concerns of hard turning are tooling cost and the effect of process on machining characteristics. The poor selection of this parameters may cause excessive tool wear and increased surface roughness. Hence there is a need to find the right parameters to achieve the right dimensional accuracy, good surface and maximum material removal rate. This paper reviews the effects of various process parameters such as cutting speed, depth of cut and feed rate on the response parameters such as surface roughness, material removal rate and chip reduction coefficient. Through this study main cutting parameters which affect the turning operation are discussed.


Keywords: CBN, HCHCR CUTTING SPEED, FEED, DEPTH OF CUT


Edition: Volume 6 Issue 5, May 2017,


Pages: 2014 - 2017


How to Cite this Article?

Dnyaneshwar. B. Unawane, K. J. Godihal, "Review on Optimization Process Parameters of HCHCR, OHNS, EN24 Materials", International Journal of Science and Research (IJSR), https://www.ijsr.net/get_abstract.php?paper_id=ART20172845, Volume 6 Issue 5, May 2017, 2014 - 2017

How to Share this Article?

Enter Your Email Address


Similar Articles with Keyword 'FEED'

Downloads: 100

Research Paper, Manufacturing Engineering, China, Volume 5 Issue 1, January 2016

Pages: 1505 - 1508

Simulation and Optimization of Aviation Integral Impeller Machining Based on VERICUT

Hui Lu, Yujun Cai, Guohe Li

Share this Article

Downloads: 108

Comparative Studies, Manufacturing Engineering, India, Volume 4 Issue 3, March 2015

Pages: 1291 - 1294

Experimental Investigation on Surface Roughness in Finish Turning of EN 8 Steel

K. G. Nikam, S. V. Vanjari

Share this Article

Similar Articles with Keyword 'DEPTH OF CUT'

Downloads: 108

Comparative Studies, Manufacturing Engineering, India, Volume 4 Issue 3, March 2015

Pages: 1291 - 1294

Experimental Investigation on Surface Roughness in Finish Turning of EN 8 Steel

K. G. Nikam, S. V. Vanjari

Share this Article

Downloads: 123

Research Paper, Manufacturing Engineering, India, Volume 3 Issue 9, September 2014

Pages: 138 - 145

Trade Off Among Conflicting Multi Objectives of CNC End Milling Process for LM6 Al/SiCp

Neeraj Kumar, K. K. Chhabra

Share this Article
Top