Abstract: Design and Fabrication of SCARA Robot with 5 Degree of Freedom
International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Open Access | Fully Refereed | Peer Reviewed

ISSN: 2319-7064

Downloads: 124 | Monthly Hits: ⮙1

Research Paper | Mechanical Engineering | India | Volume 6 Issue 3, March 2017

Design and Fabrication of SCARA Robot with 5 Degree of Freedom

Banoth Bhadru, D. Narendar, B. Kiran

These Robots are autonomous systems which can perform desired tasks in unstructured environments without continuous human guidance. Many kinds of robots are autonomous to some degree. Different robots can be autonomous in different ways the daunting task is delays and interruptions in robotic communication system. Control of the robotic arm has been achieved successfully by using servo motors. The micro-controllers implement inverse kinematics algorithms and position control is achieved through Stepper motors. The stepper motors are actuated using the internal stepper motor drivers and servomotors are controlled directly by micro controller. The robotic arm also has the provision of being controlled. The end effecter is a two finger gripper. The robotic arm has a load bearing capacity of around 100gms. The micro controller is programmed such that all the movements of the robot are synchronized to achieve Switches and force sensors are deployed for safety and continuous running of robot. For a robot it is obviously important that it can operate from batteries. Since the micro-controller runs with 5V and motors are with 6V. The main objective is to study the motion constrains and redundancies in positioning the gripper. An extensive study carried out for understanding inertia affect on links due to velocities and acceleration. Axon micro controller which is exclusively designed for robot is used and the software is implemented in embedded system and written in C and C++.

Keywords: micro controllers, stepper motor, servo motors, inverse kinematics

Edition: Volume 6 Issue 3, March 2017

Pages: 1561 - 1565

Share this Article

How to Cite this Article?

Banoth Bhadru, D. Narendar, B. Kiran, "Design and Fabrication of SCARA Robot with 5 Degree of Freedom", International Journal of Science and Research (IJSR), https://www.ijsr.net/search_index_results_paperid.php?id=ART20171812, Volume 6 Issue 3, March 2017, 1561 - 1565

Enter Your Email Address


Similar Articles with Keyword 'micro'

Downloads: 177 | Monthly Hits: ⮙1

Survey Paper, Mechanical Engineering, India, Volume 8 Issue 6, June 2019

Pages: 2320 - 2324

A Review Paper on Electro Chemical Discharge Machining Technique

Rajeev Sharma

Share this Article

Downloads: 0

Research Paper, Mechanical Engineering, Turkey, Volume 10 Issue 7, July 2021

Pages: 1327 - 1329

Investigation of the Effect of Normalization Process on Mechanical Properties and Microstructure of the AISI 4140 Alloy Steel

Yusuf YILMAZ, Ethem KESTI

Share this Article

Similar Articles with Keyword 'controllers'

Downloads: 111

Research Paper, Mechanical Engineering, Turkey, Volume 8 Issue 12, December 2019

Pages: 635 - 640

The Control of Seat Suspension System Using Fuzzy Controller on Vehicle Model

Bekir Cirak

Share this Article

Downloads: 115

M.Tech / M.E / PhD Thesis, Mechanical Engineering, India, Volume 4 Issue 7, July 2015

Pages: 2433 - 2438

Efficiency Enhancement of a Vacuum Absorption Machine in Chilled Water Plant

Patnayakuni Anitha, M.L.S. Deva Kumar, G.Venkateswarulu

Share this Article

Similar Articles with Keyword 'motor'

Downloads: 2 | Weekly Hits: ⮙1 | Monthly Hits: ⮙1

Research Paper, Mechanical Engineering, India, Volume 10 Issue 7, July 2021

Pages: 425 - 428

RF Controlled Floor Cleaning Machine

Aadil Rehman Singh

Share this Article

Downloads: 48

Research Paper, Mechanical Engineering, Indonesia, Volume 8 Issue 7, July 2019

Pages: 1790 - 1796

The Influence Comparison of the Mass Refrigerant towards Coefficient of Performance Car Air - Conditioning Systems with Refrigerant R-134A

Agil Luthfi Wal'afiah, Sunyoto

Share this Article

Similar Articles with Keyword 'servo'

Downloads: 5

Research Paper, Mechanical Engineering, India, Volume 10 Issue 5, May 2021

Pages: 676 - 678

Fluidic Electronics: Logic Gates

Vishal V R Nandigana

Share this Article

Downloads: 124

Case Studies, Mechanical Engineering, India, Volume 4 Issue 4, April 2015

Pages: 620 - 623

Comparative Analysis of Energy Efficiecy Ratio & Electric Power Consumption of Domestic Refrigerator using Refrigerant R134a & R600a at Constant Evaporator Temprature

Mujahid Sheikh, Mohd.Abuzar Qureshi

Share this Article

Similar Articles with Keyword 'motors'

Downloads: 48

Research Paper, Mechanical Engineering, Indonesia, Volume 8 Issue 7, July 2019

Pages: 1790 - 1796

The Influence Comparison of the Mass Refrigerant towards Coefficient of Performance Car Air - Conditioning Systems with Refrigerant R-134A

Agil Luthfi Wal'afiah, Sunyoto

Share this Article

Downloads: 113

Research Paper, Mechanical Engineering, China, Volume 4 Issue 12, December 2015

Pages: 1988 - 1994

Design and Simulation of Parallel Manipulator for Vehicle Driving Simulator

Khalid Ali Abdelaziz Ali, Liu Ying

Share this Article

Similar Articles with Keyword 'inverse'

Downloads: 106

Research Paper, Mechanical Engineering, India, Volume 4 Issue 5, May 2015

Pages: 1768 - 1772

Modelling of An Industrial Blast Furnance Using Finite Element Method

Khushboo Borasi, Avin Chandrakar

Share this Article

Downloads: 113

Research Paper, Mechanical Engineering, Indonesia, Volume 6 Issue 5, May 2017

Pages: 2294 - 2298

Analysis of Effect Change of Side Entry Nozzle Angle on Friction Coefficient of Fluid Flow in Pipes

Natsir Thamrin, Nasaruddin Salam, Rustan Tarakka

Share this Article

Similar Articles with Keyword 'kinematics'

Downloads: 126

Research Paper, Mechanical Engineering, China, Volume 5 Issue 1, January 2016

Pages: 1064 - 1068

Motion Planning and Trajectory for Wheeled Mobile Robot

Sheha Ame Mnubi

Share this Article

Downloads: 129

Research Paper, Mechanical Engineering, China, Volume 2 Issue 11, November 2013

Pages: 391 - 395

Research on 6 DOF - Steward Platform Mechanical Characteristics Analysis and Optimization Design

Husameldeen Mustafa Mohammed, Hu Deji

Share this Article
Top