International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Since Year 2012 | Open Access | Fully Refereed | Peer Reviewed

ISSN: 2319-7064

Downloads: 129

Research Paper | Mechanical Engineering | India | Volume 5 Issue 9, September 2016

Analysis of Calcination Drums under Static and Dynamic Conditions

Sonal Uttam Potdar | Prof. V. J. Khot

Abstract: Solid waste management is posing a great problem as the population is increasing day by day. The municipal sewage waste has to be disposed properly otherwise it will lead to air pollution and cause the serious effects on the health of human beings. The most common practice adopted is generating methane from municipal solid waste. For this purpose it is necessary that the municipal solid waste which is sent for further processing should be in the form of homogenous mass. In order to form the homogenous mass it is necessary that it should be separated in degradable and non degradable. This degradable waste is then converted into fine particles. To achieve this task the engineers have designed a special instrument named Calcination Drum. Usually Calcination Drum is also known as Rotary Kilns. In primary stage when the Calcination Drum was implemented it was found that some problems were encountered. The main aim of this project is to solve the problems related to guide ring and support roller shaft of Calcination Drum. Analysis of roller shaft, roller and Calcination drum is carried out and the stress as well as deformation is found out in static and dynamic condition. For theoretical calculations of shaft the standard data is taken from design data book and for guide ring Hertz contact stress theory is used.

Keywords: Calcination Drum, Support Roller Shaft, Guide ring, Roller, ANSYS software

Edition: Volume 5 Issue 9, September 2016,

Pages: 362 - 367

How to Cite this Article?

Sonal Uttam Potdar, Prof. V. J. Khot, "Analysis of Calcination Drums under Static and Dynamic Conditions", International Journal of Science and Research (IJSR), Volume 5 Issue 9, September 2016, pp. 362-367,

How to Share this Article?

Enter Your Email Address

Similar Articles with Keyword 'Roller'

Downloads: 5 | Weekly Hits: ⮙2 | Monthly Hits: ⮙2

Student Project, Mechanical Engineering, India, Volume 10 Issue 11, November 2021

Pages: 1143 - 1148

Design and Fabrication of Pick and Place Robot using Microcontroller

Avinash N Bhat | Abhishek Yalnaik

Share this Article

Downloads: 107

Research Paper, Mechanical Engineering, India, Volume 3 Issue 8, August 2014

Pages: 1434 - 1439

Analysis of Angular Contact Ball Bearings Design

S. R. Dutta [3] | S. K. Singh [9] | R. Ranjan [10]

Share this Article