International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Since Year 2012 | Open Access | Fully Refereed | Peer Reviewed

ISSN: 2319-7064




Downloads: 141

Research Paper | Mechanical Engineering | India | Volume 6 Issue 7, July 2017


Effect of Process Parameters on the Performance of Micro-EDM

Vasantha Prasath N | Mohanraj R [2] | Nandhakumar M


Abstract: Electrical discharge machining (EDM) is an important process in the field of micro machining. However, a number of issues remain to be solved in order to successfully implement it in an industrial environment. One of these issues is the processing time. This paper investigates the optimization of machining parameters for Material Removal Rate and over cut in micro EDM. In one case, the parameters are selected to achieve the highest material removal rate (MRR). In the other case, the lower over cut is targeted. Some of the main difficulties linked with micro EDM are caused by the high wear occurring on the electrode. The study focuses on a specific combination of electrode and workpiece material and proposes a typical method for micro EDM process.


Keywords: Electrical Discharge Machining, Orthogonal Array, Taguchi Method, S/N Ratio, 304 Stainless steel


Edition: Volume 6 Issue 7, July 2017,


Pages: 629 - 634

Effect of Process Parameters on the Performance of Micro-EDM


How to Cite this Article?

Vasantha Prasath N, Mohanraj R, Nandhakumar M, "Effect of Process Parameters on the Performance of Micro-EDM", International Journal of Science and Research (IJSR), https://www.ijsr.net/get_abstract.php?paper_id=7071711, Volume 6 Issue 7, July 2017, 629 - 634, #ijsrnet

How to Share this Article?

Enter Your Email Address




Similar Articles with Keyword 'Electrical Discharge Machining'

Downloads: 49

Research Paper, Mechanical Engineering, India, Volume 10 Issue 1, January 2021

Pages: 1124 - 1127

Effect of Various Parameters on Machining of EN-31 in Wire Electrical Discharge Machining

Rajat [40] | Shiv Kumar [16]

Share this Article

Downloads: 119

Research Paper, Mechanical Engineering, India, Volume 6 Issue 7, July 2017

Pages: 1634 - 1637

Effect of Machining Parameters in Electrical Discharge Machining of D2 Tool Steel

Raman K [2] | Sathiya G K | Saisujith K | Mani P [15]

Share this Article


Top