International Journal of Science and Research (IJSR)

International Journal of Science and Research (IJSR)
Call for Papers | Open Access | Double Blind Peer Reviewed

ISSN: 2319-7064

Downloads: 109 | Views: 119

Research Paper | Manufacturing Engineering | India | Volume 3 Issue 5, May 2014

Parametric Optimization of TIG welding of Galvanized Steel with AA1050 using Taguchi Method

J. Pasupathy | V. Ravisankar | C. Senthilkumar

Abstract: Tungsten Inert Gas welding (TIG) process is an important component in many industrial operations. The TIG welding parameters are the most important factors affecting the quality; productivity and cost of welding. Dissimilar welding of metal having different mechanical and physical properties is very difficult. The process tried here is weld brazing process. A filler rod is selected in such a way that it is compatible to both GI and Aluminium. On the aluminum side the filler rod will have proper fusion whereas on the Galvanized steel side the process will be a brazing operation in which a thin intermetallic layer is formed between the seam and the sheet. This paper presents the influence of welding parameters like welding current; welding speed and frequency on strength of Galvanized steel on AA1050 material during welding. A plan of experiments based on Taguchi technique has been used to acquire the data. An Orthogonal array; signal to noise (S/N) ratio and analysis of variance (ANOVA) are employed to investigate the welding characteristics of dissimilar joint and optimize the welding parameters. Finally the conformations tests have been carried out to compare the predicted values with the experimental values to confirm its effectiveness in the analysis of strength.

Keywords: TIG welding, weld brazing, optimization, orthogonal array, S/N ratio

Edition: Volume 3 Issue 5, May 2014,

Pages: 1011 - 1015

How to Download this Article?

Type Your Email Address below to Download the Article PDF

How to Cite this Article?

J. Pasupathy, V. Ravisankar, C. Senthilkumar, "Parametric Optimization of TIG welding of Galvanized Steel with AA1050 using Taguchi Method", International Journal of Science and Research (IJSR), Volume 3 Issue 5, May 2014, pp. 1011-1015,

Similar Articles with Keyword 'optimization'

Downloads: 0

Experimental Result Paper, Manufacturing Engineering, Vietnam, Volume 11 Issue 6, June 2022

Pages: 1224 - 1227

Multi-Objective Optimization of Turning Parameters to Minimize Surface Roughness and Material Removal Rate Using TOPSIS Combining Entropy Weight

Nguyen Anh Thang | Truong Van Luong | Tran Van Hieu

Share this Article

Downloads: 91

Informative Article, Manufacturing Engineering, India, Volume 8 Issue 12, December 2019

Pages: 1845 - 1848

Fabrication of Folded Wave Guide Structure by Laser Micromachining

Mounashree B S | Mr Sudhir B S

Share this Article